Getting Started: Adding your NVR to the VIVOCloud application using the QR code/device ID

In order to add your VIVOCloud compatible device, you need to use a QR code or Device ID. This document will explain where to find this information:

Enabling the Service:

Before being able to add your device using its QR code or Device ID, you need to ensure that the VIVOCloud service is enabled. First, log in to your NVR device using its username and password.

Once you have accessed the device, click on the gear icon to access the NVR configurations.

In the Settings interface, select the System tab and click on "VIVOCloud service".

In the VIVOCloud service interface, you will see a "blue" button (old interface) or a "gray" button (new interface). Clicking this button will enable the VIVOCloud service on your NVR.

After clicking it, the NVR will start connecting to the VIVOCloud server and register the service (this might take 1-2 minutes depending on your internet connection). Once the connection is established and the device is registered in the cloud system, a QR code and Device ID will be displayed below.

If you are using the local console, follow the same steps, as both the Local and Web interfaces are the same in this regard.

Adding the device to the VIVOCloud application:

In the VIVOCloud application, go to the configuration menu and select "Add devices" to add your NVR. Then, click on the "Add devices manually" section. Here, you will be allowed to choose between using a QR code or the device ID.

Using the Device ID

Type the Pcode/Device ID found on the NVR VIVOCloud service webpage and click on the "+" button to add the NVR to the VIVOCloud application.

Using the QR Code

Click on the QR button to scan the QR code on the webpage using your phone camera (make sure to allow the application access to the camera).

Once finished, you will be able to see your NVR cameras in the VIVOCloud application.