How to export debug logs and enable remote access function from ND-Series NVR(Linux-based)?

Starts from firmware version v4.1 of ND/NV-Series NVR, VIVOTEK add remote access function on the customer support page.

Please follow the step below to export debug logs and enable remote access* function to get access ID:

There are two ways to access the NVR, please choose which one you access to NVR. 

Web console.

Local console.

Note 1:
1.Remember to provide MAC address of ND-Series NVR at the same time when providing the access ID.
2. Remote access has 14 days validity.

Note 2:
* Important Notice *
The ND9213P, ND9323P and ND9425P NVR remote access service for customer support will be temporarily stopped starting from Feb. 7th, 2022 until the middle of April, 2022 due to service maintenance and firmware tunning. After the proper changes have been done in the cloud platform and the firmware, VIVOTEK will release an statement informing the new NVR firmware v4.1 release and will resume the remote services for those specific models.
For ND9441. ND9541, ND9441P, ND9541P, ND9322P, ND9424P, ND9322P-v2 and ND9424P-v2, remote cloud service will NOT be supported. 

Web console.

• Go to setting>System>Customer support page
  (A). Export debug logs.
  (B). Enable remote access.(OFF->ON)
  (C). Cope Access ID.
  
  

Local console.

• Go to setting>System>Customer support page
  (A). Export debug logs.
  (B). Enable remote access.(OFF->ON)
  (C). Cope Access ID.